Stainless Steel Panel Mounting Clips – 50 Pack

Concealed clips for mechanically fixing WPC fluted panels – 50 per pack.

These clips screw to the substrate and engage the rebate on the back of a Luxora WPC fluted panel, holding it flat without adhesive and without any visible fixing on the face. Three slotted holes per clip allow small adjustments as a run is levelled.

Mechanical fixing is the right method over battens, uneven masonry, and anywhere a panel may need to come off again – a rented fit-out, an exhibition stand, or a wall with services behind it. Allow roughly four clips per panel; one 50-pack covers about 12 panels.

Best for

• Fixing fluted panels over battens or uneven walls
• Installations that must be demountable
• Ceiling and soffit runs where adhesive alone is not enough
• Commercial projects requiring mechanical fixing

Highlights

• Cut to 114 in — a single length runs the full height of a Luxora panel
• Factory finish — colour-matched to the Luxora panel range
• Conceals cut edges and absorbs wall tolerance at corners
• Fixes with adhesive or pins before the adjoining panel is set
• Cuts with a hacksaw or mitre saw using a metal-cutting blade

Specifications

Care & Maintenance

Wipe with a soft damp cloth. On polished stainless finishes, dry after cleaning to avoid water spotting. Do not use abrasive pads or chlorine-based cleaners.

Shipping & Ordering

Supplied in 114 in lengths and shipped in a rigid tube or with the panel order. Allow one length per corner or joint, plus 10% for cuts.