Aluminum Alloy Inside Corner Trim – Black | 25/64 x 114 in

Black internal corner profile – closes the gap where two panelled walls meet.

Internal corners are the hardest detail to cut cleanly on a 2.8 mm sheet, because any variation in the wall angle shows as a shadow gap. This V profile absorbs that tolerance: the panels butt into either flank and the moulded corner covers the joint.

Supplied in black to match the Luxora panel range, cut to 114 in so a single length runs the full height of a panel with nothing to align mid-wall.

Best for

• Finishing exposed panel edges at doorways, windows, and wall ends
• Covering the joint where two sheets meet on a long run
• Internal and external corners on feature walls and columns
• Commercial fit-outs where a crisp, repeatable detail is required

Highlights

• Cut to 114 in — a single length runs the full height of a Luxora panel
• Factory finish — colour-matched to the Luxora panel range
• Conceals cut edges and absorbs wall tolerance at corners
• Fixes with adhesive or pins before the adjoining panel is set
• Cuts with a hacksaw or mitre saw using a metal-cutting blade

Specifications

Care & Maintenance

Wipe with a soft damp cloth. On polished stainless finishes, dry after cleaning to avoid water spotting. Do not use abrasive pads or chlorine-based cleaners.

Shipping & Ordering

Supplied in 114 in lengths and shipped in a rigid tube or with the panel order. Allow one length per corner or joint, plus 10% for cuts.