Stainless Steel T Trim – Gold | 114 in

Mirror-polished gold T profile that hides the joint between two panels.

The T profile drops into the gap between two adjoining sheets, with the stem concealed behind the panels and only the polished gold face showing. It turns an unavoidable joint into a deliberate design line.

Because the face is narrow, a run of T trims reads as a series of thin metal pinstripes down the wall – the standard detail for breaking a very wide feature wall into proportioned bays.

Best for

• Finishing exposed panel edges at doorways, windows, and wall ends
• Covering the joint where two sheets meet on a long run
• Internal and external corners on feature walls and columns
• Commercial fit-outs where a crisp, repeatable detail is required

Highlights

• Cut to 114 in — a single length runs the full height of a Luxora panel
• Factory finish — colour-matched to the Luxora panel range
• Conceals cut edges and absorbs wall tolerance at corners
• Fixes with adhesive or pins before the adjoining panel is set
• Cuts with a hacksaw or mitre saw using a metal-cutting blade

Specifications

Care & Maintenance

Wipe with a soft damp cloth. On polished stainless finishes, dry after cleaning to avoid water spotting. Do not use abrasive pads or chlorine-based cleaners.

Shipping & Ordering

Supplied in 114 in lengths and shipped in a rigid tube or with the panel order. Allow one length per corner or joint, plus 10% for cuts.